MWDAM-1057/1056:
For design results, the actual values for all kind of Z-values which are based on the redesigned surface line 
are corrrected in the new UI.

MWDAM-1057/1056
For design results, the profilename and the profile probability are now always filled.

MWDAM-1057/1056
When performing a calculation, selected but not relevant calculations are now given back in the calcultion log
as not relevant to inform the user. An example of this is when a location is selected with both piping as well
as stability profiles but only a stability calculation is performed. The, for each piping profile a message is
logged to say that this is not relevant. Also, when calculations fail the preparation stage of the calculation
this is logged to inform the user.

MWDAM-1057
The combination of outwards stability and zone areas is no longer allowed.

MWDAM-1161
In Release, when for model BishopUpliftVan an UpliftVan calculation failed for one the location-profile combinations, all the combinations for this location were not calculated with Bishop anymore. In new version all combinations are calculated. When one the calculations fails, the overall result for this combination is the failed one.