Index: DamClients/DamUI/trunk/doc/DAM UI - Functional Design/DAM_UI_FO.tex
===================================================================
diff -u -r6887 -r6889
--- DamClients/DamUI/trunk/doc/DAM UI - Functional Design/DAM_UI_FO.tex	(.../DAM_UI_FO.tex)	(revision 6887)
+++ DamClients/DamUI/trunk/doc/DAM UI - Functional Design/DAM_UI_FO.tex	(.../DAM_UI_FO.tex)	(revision 6889)
@@ -94,10 +94,6 @@
 I can either just calculate the safety factors of the current situation or design (adapt geometry) to a required safety factor.
 The design of this functionality is described in \autoref{sec:USCreateDesignProject}.
 
-\section{Obsolete: User story Create Calamity project}
-As a geotechnical engineer I want to create a Calamity project in which I can import project information and perform calculations based on a time serie of water levels and evaluate the results.
-The design of this functionality is described in \autoref{sec:USCreateCalamityProject}.
-
 \section{User story DAMLive configuration}
 As a geotechnical engineer I want to make a DAMLive configuration, so that I can make calculations with DAM engine, using sensors for the input of piezometric lines. 
 The design of this functionality is described in \autoref{sec:USDAMLiveConfiguration}.
@@ -132,11 +128,6 @@
 create a berm or a combination of these options according to given settings.
 The design of this functionality is described in \autoref{sec:USCalculationDesignWithAdaption}.
 
-\section{Obsolete: User story Perform Calamity calculation}
-As a geotechnical engineer I want to be able to make a calculation in a Calamity project. 
-After importing a time series of water levels the safety factors will be calculated for all locations and for all time steps.
-The design of this functionality is described in \autoref{sec:USCalculationCalamity}.
-
 \section{User story Display results in table form}
 As a geotechnical engineer I want to see the results of the calculations, so I can evaluate the calculations. 
 The design of this functionality is described in \autoref{sec:USDisplayResultsTable}.