Index: DamEngine/trunk/src/Deltares.DamEngine.Interface/FillDamFromXmlOutput.cs
===================================================================
diff -u -r6217 -r6404
--- DamEngine/trunk/src/Deltares.DamEngine.Interface/FillDamFromXmlOutput.cs	(.../FillDamFromXmlOutput.cs)	(revision 6217)
+++ DamEngine/trunk/src/Deltares.DamEngine.Interface/FillDamFromXmlOutput.cs	(.../FillDamFromXmlOutput.cs)	(revision 6404)
@@ -1,4 +1,4 @@
-// Copyright (C) Stichting Deltares 2024. All rights reserved.
+// Copyright (C) Stichting Deltares 2025. All rights reserved.
 // 
 // This file is part of the Dam Engine.
 // 
@@ -94,6 +94,7 @@
                     timeSerieEntry.BishopCircleCentreZ = entry.BishopCalculatedSlipPlane.Center.Z;
                     timeSerieEntry.BishopCircleRadius = entry.BishopCalculatedSlipPlane.Radius;
                 }
+
                 timeSerie.Entries.Add(timeSerieEntry);
             }
         }
@@ -284,7 +285,7 @@
         for (var j = 0; j < inputSurfaceLine.Points.Length; j++)
         {
             SurfaceLinePoint inputPoint = inputSurfaceLine.Points[j];
-            var geometryPoint = new Point2D()
+            var geometryPoint = new Point2D
             {
                 X = inputPoint.X,
                 Z = inputPoint.Z
@@ -366,9 +367,9 @@
                 desResult.StabilityDesignResults.PassiveCenterPointRadius = dualSlipCircleDefinition.PassiveCircleRadius;
             }
 
-            if (designResult.StabilityDesignResults.StabilityModelType is 
-                DesignResultStabilityDesignResultsStabilityModelType.Bishop or 
-                DesignResultStabilityDesignResultsStabilityModelType.UpliftVan or 
+            if (designResult.StabilityDesignResults.StabilityModelType is
+                DesignResultStabilityDesignResultsStabilityModelType.Bishop or
+                DesignResultStabilityDesignResultsStabilityModelType.UpliftVan or
                 DesignResultStabilityDesignResultsStabilityModelType.BishopUpliftVan)
             {
                 if (designResult.StabilityDesignResults.SlipCircleDefinition.Slices != null)