Index: DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs
===================================================================
diff -u -r5993 -r6086
--- DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs	(.../WtiPipingSellmeijerRevisedTests.cs)	(revision 5993)
+++ DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs	(.../WtiPipingSellmeijerRevisedTests.cs)	(revision 6086)
@@ -157,8 +157,8 @@
 
         // The expected values below where calculated with DamEngine rev.2012,
         // The following test are different from CanPerformWtiSellmeijerRevisedDesignWithAdaptionPipingVoorbeeld1()
-        Assert.That(redesignedSurfaceLine.CharacteristicPoints.GetGeometryPoint(CharacteristicPointType.DikeTopAtRiver).Z, Is.EqualTo(4.5).Within(tolerance));
-        Assert.That(redesignedSurfaceLine.CharacteristicPoints.GetGeometryPoint(CharacteristicPointType.DikeTopAtPolder).Z, Is.EqualTo(4.5).Within(tolerance));
+        Assert.That(redesignedSurfaceLine.CharacteristicPoints.GetPoint2D(CharacteristicPointType.DikeTopAtRiver).Z, Is.EqualTo(4.5).Within(tolerance));
+        Assert.That(redesignedSurfaceLine.CharacteristicPoints.GetPoint2D(CharacteristicPointType.DikeTopAtPolder).Z, Is.EqualTo(4.5).Within(tolerance));
 
         // Note Bka: Answers here are 17 meter longer shoulder than Sellmeijer4Forces from which these tests are derived.
         // ShoulderWidth = X_Kruin binnenberm - X_Insteek binnenberm = 65.01 - 32.01 = 33.0 + 17 = 50