Index: DamEngine/trunk/src/Deltares.DamEngine.Interface.Tests/PipingBlighTests.cs
===================================================================
diff -u -r1358 -r1363
--- DamEngine/trunk/src/Deltares.DamEngine.Interface.Tests/PipingBlighTests.cs	(.../PipingBlighTests.cs)	(revision 1358)
+++ DamEngine/trunk/src/Deltares.DamEngine.Interface.Tests/PipingBlighTests.cs	(.../PipingBlighTests.cs)	(revision 1363)
@@ -121,7 +121,7 @@
             Assert.AreEqual(true, output.Results.CalculationResults.DesignResults[0].PipingDesignResults.UpliftSituation.IsUplift);
             Assert.AreEqual(1.995, redesignedSurfaceLine.DetermineShoulderHeight(), tolerance);
             Assert.AreEqual(63.486, redesignedSurfaceLine.GetDikeLength(), tolerance);
-            Assert.AreEqual(32.5, redesignedSurfaceLine.DetermineShoulderWidth(), tolerance);
+            Assert.AreEqual(32.5, redesignedSurfaceLine.DetermineShoulderLength(), tolerance);
             Assert.AreEqual(0.0, output.Results.CalculationResults.DesignResults[0].PipingDesignResults.UpliftSituation.Pl3MinUplift, tolerance);
             Assert.AreEqual(0.0, output.Results.CalculationResults.DesignResults[0].PipingDesignResults.UpliftSituation.Pl3HeadAdjusted, tolerance);
             Assert.AreEqual(0.0, output.Results.CalculationResults.DesignResults[0].PipingDesignResults.UpliftSituation.Pl3LocationXMinUplift, tolerance);
@@ -182,7 +182,7 @@
             Assert.AreEqual("Location 101, subsoil scenario 'segment1_1D1', design scenario '1': " +
                             "The calculation failed with error message " +
                             "'The design was not successful. " +
-                            "The new shoulder width is too large to fit in the current surface line.'",
+                            "The new shoulder length is too large to fit in the current surface line.'",
                 output.Results.CalculationMessages[0].Message1);
 
         }