Index: DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/PipingSellmeijerRevisedTests.cs
===================================================================
diff -u -r1818 -r1896
--- DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/PipingSellmeijerRevisedTests.cs	(.../PipingSellmeijerRevisedTests.cs)	(revision 1818)
+++ DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/PipingSellmeijerRevisedTests.cs	(.../PipingSellmeijerRevisedTests.cs)	(revision 1896)
@@ -34,7 +34,7 @@
         private const double tolerance = 0.0005;
 
         [Test]
-        public void CanPerformSellmeijer4RevisedDesignPipingVoorbeeld1()
+        public void CanPerformSellmeijerRevisedDesignPipingVoorbeeld1()
         {
             // Based on ".\data\DamEngineTestProjects\PipingVoorbeeld1\PipingSellmeijerRevised.damx"
             // Set Analysis type to "No Adaption"
@@ -74,7 +74,7 @@
         }
 
         [Test]
-        public void CanPerformSellmeijer4ForcesDesignWithAdaptionPipingVoorbeeld1()
+        public void CanPerformSellmeijerRevisedDesignWithAdaptionPipingVoorbeeld1()
         {
             // Based on ".\data\DamEngineTestProjects\PipingVoorbeeld1\PipingSellmeijerRevised.damx"
             // Set Analysis type to "Adapt geometry"
@@ -118,7 +118,7 @@
         }
 
         [Test]
-        public void CanPerformSellmeijer4ForcesDesignWithAdaptionWithHeightPipingVoorbeeld1()
+        public void CanPerformSellmeijerRevisedDesignWithAdaptionWithHeightPipingVoorbeeld1()
         {
             // Based on ".\data\DamEngineTestProjects\PipingVoorbeeld1\PipingSellmeijerRevised.damx"
             // Set Analysis type to "Adapt geometry"