Index: DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex
===================================================================
diff -u -r2396 -r2744
--- DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex	(.../UseStabKernel.tex)	(revision 2396)
+++ DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex	(.../UseStabKernel.tex)	(revision 2744)
@@ -50,23 +50,18 @@
 \label{sec:TangentLinesGeneration}
 For the models Bishop and LiftVan a tangent lines must be generated.
 
-There are two options:
-\begin{enumerate}
-	\item automatic generation
-	\item client defined generation
-\end{enumerate}
 
-Ad 1 Automatic generation\newline
-Bishop\newline
--to described-\newline
-Liftvan\newline
--to described-\newline
+Bishop: Automatic generation\newline
+The tangent lines are placed from the minimum Z-value of the surface line until 0.5 m below the upper geometry point of the lowest aquifer. The distance between the tangent lines is 0.25 m.
 
-Ad 2 Client defined\newline
-For Bishop calcuations the tangent lines can not be defined by the client.\newline
+LiftVan: Client defined\newline
+Distance defined - Naar opgave afstand
 For LiftVan the client must provide the distance between the tangent lines.
-The lower tangentline is always situated 5.0 m below the upper geometry point of the lowest aquifer. The tangentlines are drawn with the given distance until the upper tangent line is situated above the Z DikeToeAtPolder.
+The lower tangentline is always situated 0.5 m below the upper geometry point of the lowest aquifer. The tangent lines are drawn with the given distance until the upper tangent line is situated above the Z DikeToeAtPolder.
 
+On boundary - Op laagscheidingen
+On every boundary of the subsoil layer below Z DikeToeAtPolder a tangent line is generated.
+
 \subsection{Calculation area}
 \label{sec:CalculationArea}
 For the model Horizontal balance a calculation area must be defined: