Index: DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex
===================================================================
diff -u -r2744 -r2745
--- DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex	(.../UseStabKernel.tex)	(revision 2744)
+++ DamEngine/trunk/doc/Dam Engine - Functional Design/UseStabKernel.tex	(.../UseStabKernel.tex)	(revision 2745)
@@ -44,24 +44,21 @@
 
 Ad 2 Client defined generation\newline
 The client defines the dimensions; number of gridpoints and distance between the points. The \ProgramName defines the position of the grid depending on the characteristic points:
-For Bishop and for the left grid of LiftVan the left (outside) bottom corner is situated at the surfaceline in the middle of the crest (distance between outer- and innercrest). The right bottom corner of the right (inside) grid of LiftVan is situated above the most right x co-ordinate where uplift occurs. With the restriction that the left bottom corner can not be situated left of the x co-ordinate of the DikeToePolder.	
+For Bishop and for the active grid of LiftVan the left (outside) bottom corner is situated at the surfaceline in the middle of the crest (distance between outer- and innercrest). The right bottom corner of the passive grid of LiftVan is situated above the most right x co-ordinate where uplift occurs. With the restriction that the left bottom corner can not be situated left of the x co-ordinate of the DikeToePolder.	
 	
 \subsection{Tangent lines generation}
 \label{sec:TangentLinesGeneration}
-For the models Bishop and LiftVan a tangent lines must be generated.
 
-
-Bishop: Automatic generation\newline
+For the Bishop model only automatic generation is used.\newline
 The tangent lines are placed from the minimum Z-value of the surface line until 0.5 m below the upper geometry point of the lowest aquifer. The distance between the tangent lines is 0.25 m.
 
-LiftVan: Client defined\newline
-Distance defined - Naar opgave afstand
+For LiftVan there are two client defined methods\newline
+Distance defined - Naar opgave afstand\newline
 For LiftVan the client must provide the distance between the tangent lines.
-The lower tangentline is always situated 0.5 m below the upper geometry point of the lowest aquifer. The tangent lines are drawn with the given distance until the upper tangent line is situated above the Z DikeToeAtPolder.
+The lower tangent line is always situated 0.5 m below the boundary of the upper aquifer. The tangent lines are drawn with the given distance until the minimum Z value of the passive grid.\newline
+On boundary - Op laagscheidingen (default)\newline
+On every boundary of the subsoil layer.
 
-On boundary - Op laagscheidingen
-On every boundary of the subsoil layer below Z DikeToeAtPolder a tangent line is generated.
-
 \subsection{Calculation area}
 \label{sec:CalculationArea}
 For the model Horizontal balance a calculation area must be defined: