Index: DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs
===================================================================
diff -u -r5246 -r5257
--- DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs	(.../WtiPipingSellmeijerRevisedTests.cs)	(revision 5246)
+++ DamEngine/trunk/src/Deltares.DamEngine.IntegrationTests/IntegrationTests/WtiPipingSellmeijerRevisedTests.cs	(.../WtiPipingSellmeijerRevisedTests.cs)	(revision 5257)
@@ -193,20 +193,16 @@
 
         Assert.Multiple(() =>
         {
-            // The expected values below where calculated with DamEngine rev.2016,
             Assert.That(output.Results.CalculationResults, Has.Length.EqualTo(112));
             Assert.That(ConversionHelper.ConvertToCalculationResult(output.Results.CalculationResults[0].CalculationResult), Is.EqualTo(CalculationResult.Succeeded));
         });
         Assert.Multiple(() =>
         {
-            // result 1: safety factor = 90.000
             Assert.That(output.Results.CalculationResults[0].PipingDesignResults.Wti2017FactorOverall, Is.EqualTo(90.000).Within(tolerance));
-            // result 2: safety factor = 58.243
             Assert.That(ConversionHelper.ConvertToCalculationResult(output.Results.CalculationResults[2].CalculationResult), Is.EqualTo(CalculationResult.Succeeded));
             Assert.That(output.Results.CalculationResults[2].PipingDesignResults.Wti2017FactorOverall, Is.EqualTo(58.241).Within(tolerance));
-            // result 3: safety factor = 0 NB. In 18.1.3 it was 90, but now we use Uplift calculation from WBI, before from DAM
-            Assert.That(ConversionHelper.ConvertToCalculationResult(output.Results.CalculationResults[103].CalculationResult), Is.EqualTo(CalculationResult.Succeeded));
-            Assert.That(output.Results.CalculationResults[103].PipingDesignResults.Wti2017FactorOverall, Is.EqualTo(56.011).Within(tolerance));
+            Assert.That(ConversionHelper.ConvertToCalculationResult(output.Results.CalculationResults[111].CalculationResult), Is.EqualTo(CalculationResult.RunFailed));
+            Assert.That(output.Results.CalculationResults[111].PipingDesignResults.Wti2017FactorOverall, Is.EqualTo(0.000).Within(tolerance));
         });
     }