Index: DamEngine/trunk/doc/Dam Engine - Technical Design/DAM Engine - Technical Design.tex
===================================================================
diff -u -r5740 -r5789
--- DamEngine/trunk/doc/Dam Engine - Technical Design/DAM Engine - Technical Design.tex	(.../DAM Engine - Technical Design.tex)	(revision 5740)
+++ DamEngine/trunk/doc/Dam Engine - Technical Design/DAM Engine - Technical Design.tex	(.../DAM Engine - Technical Design.tex)	(revision 5789)
@@ -970,14 +970,13 @@
 	\label{tab:MappingDamEnginePreProcessMacrostability}
 \end{table}
 
-\Note{Parameter \textit{AutoSearchArea} in \autoref{tab:MappingDamEnginePreProcessMacrostability} does not work as expected if this parameter is TRUE: \\
+\Note{Parameter \textit{AutoSearchArea} in \autoref{tab:MappingDamEnginePreProcessMacrostability} does not work the same way for Bishop and Uplift-Van if this parameter is TRUE: \\
 For Bishop, the grid and tangent lines are both automatically determined 
 and if \textit{AutoTangentLines} is TRUE then the tangent lines will be overwritten by the tangent lines of the Uplift-Van model. \\
 For Uplift-Van, only the left and right grids are automatically determined, not the tangent lines.}
 
 \Note{The specified tangent lines settings \textit{TangentLineZTop}, \textit{TangentLineZBottom} and \textit{TangentLineNumber} 
-in \autoref{tab:MappingDamEnginePreProcessMacrostability} are not working correctly in Macrostability: 
-the Preprocessing Output object is empty for the tangent lines. 
+in \autoref{tab:MappingDamEnginePreProcessMacrostability} are not converted to a list of tangent lines in the Preprocessing Output object of Macrostability preventing the input stix file to be created. 
 It is therefore needed to specified the tangent lines in the object StabilityModel $\rightarrow$ BishopCalculationCircle/UpliftVanCalculationGrid $\rightarrow$ TangentLines $\rightarrow$ BoundaryHeights, see \autoref{tab:MappingDamEngineDataMacrostability}.}
 
 \begin{table}[H]